I have my "new-to-me" LM-470 bolted to the raising fixture and resting in a
horizontal position. I have been looking at the manual I have and it says to
run the raising cable up thru the upper pulley on the raising fixture then down
to the tower thru a 4" pulley and back to the original pulley on the fixture.
The drawings show a sort of bracket that is holding this pulley and the bracket
encompasses the pulley in such a way it would be nearly impossible to bind up.
I don't think I have this bracket. I have 2- 5" pulleys but I thought they
would mount on the raising fixture. I also have a few extra-but-used 3.5"
pulleys and no bracket. Do I need this bracket? Or can I simply put a bolt thru
the pulley and use the small cable assembly that came with it to loop around
the tower leg to secure the pulley to the tower?
I just wanna do it right so I am asking.
Bill AD8P
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|