The design of the KT36XA is such that it is possible (barely) to sidemount
it and have it rotate around 135 degrees. However, it can not be put on a
swing arm to achieve 300 degree rotation. The front driven and the first
director are too close to do the old swing arm on Rohn 55.
I am considering buying several TIC RINGS from TICGEN. Any comments on the
factory service, dependabilty, ease of assembly, which control box to get and
just general stuff would be appreciated. Also, just how hard is it to climb
the tower and get past the TIC ring as you climb? It looks like it juts out
quite a bit.
The model I am planning to get is the 1122E which has one motor and is
supposed to handle 20 sq ft. I plan to use it for KT36XAs and a M2 4 el 40
(13.5
sq ft).
Mahalo and 73
Bill KH7XS
**************New MapQuest Local shows what's happening at your destination.
Dining, Movies, Events, News & more. Try it out
(http://local.mapquest.com/?ncid=emlcntnew00000002)
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|