I don't think that using the electric company ground is a very good idea.
It is usually just a single ground rod that they pound into the ground near
the electric box.
Bob W6TR
----- Original Message -----
From: "David Robbins K1TTT" <k1ttt@arrl.net>
To: "'TowerTalk'" <towertalk@contesting.com>
Sent: Sunday, October 05, 2008 5:12 PM
Subject: Re: [TowerTalk] House entrance ground for RF ground?
That is exactly the right thing to do.
David Robbins K1TTT
e-mail: mailto:k1ttt@arrl.net
web: http://www.k1ttt.net
AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
> -----Original Message-----
> From: Gary Slagel [mailto:gdslagel@yahoo.com]
> Sent: Sunday, October 05, 2008 20:48
> To: TowerTalk
> Subject: [TowerTalk] House entrance ground for RF ground?
>
> Hi,
>
> My shack is on the first floor of the house and right above the electrical
> service entrance in the basement. For my station RF and DC ground, I'm
> thinking I'll run a 10' wire from the station down to the electrical
> entrance ground wire which, of course, runs right out to ground rods
> outside the house. Is there any problem with this or should I be running
> to a separate ground rod?
>
> Thanks for any opinions!
>
> Gary Slagel/N0SXX
> Hot Springs, SD
> http://marina.fortunecity.com/sanpedro/351
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|