I asked this question a long time ago on usenet and here was the
answer, which I followed:
http://groups.google.com/group/rec.radio.amateur.antenna/browse_thread/thread/896969fe57605e51/2a3ae24972edf488?hl=en&lnk=st&q=scott+yagi+leeson#2a3ae24972edf488
Check out Wes Stewarts answer which summarizes a formula from Leeson's
"Physical Design of Yagi Antennas".
-Scott, WU2X
On Sun, Oct 5, 2008 at 3:18 PM, Felipe Ceglia <felipeceglia2@gmail.com> wrote:
> Hello,
>
> Can anyone tell me if there is a way to calculate the cilindrical
> equivalent of boom-to-element plates when modeling yagi beams on YW and
> EZNEC?
>
> The antenna book have some values for its recipes, but as far as I seen,
> it doesnt say how to calculate those figures.
>
> 73 and thanks,
>
> Felipe - PY1NB
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|