Thanks Tom. I had forgotten about the opposite mounting. I thought there was
something in the text about where the tuning jumper was supposed to go as a
start and that is not on the drawing that I could see. I remember that it
was a struggle getting it tuned - up and down the tower.
73, Larry W6NWS
----- Original Message -----
From: "Tom Carrubba KA2D" <ka2d@arrl.net>
To: "Larry" <w6nws@arrl.net>
Sent: Friday, October 03, 2008 9:33 AM
Subject: Re: [TowerTalk] Force12 EF240X loading line measurement
> Larry
>
> Hope this helps, see attached.
>
> GL -Tom KA2D
>
> ----- Original Message -----
> From: "Larry" <lknain@nc.rr.com>
> To: <towertalk@contesting.com>
> Sent: Thursday, October 02, 2008 1:25 PM
> Subject: [TowerTalk] Force12 EF240X loading line measurement
>
>
>>I have misplaced my instructions for my EF240X. I had to rebuild it after
>>one element fell off and getting down and unbalanced antenna was a bit
>>tough on the other element. I am looking for the starting measurements for
>>the shorting line for the loading lines for both the DE and reflector
>>elements.
>>
>> Thanks
>>
>> Larry W6NWS
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
> --------------------------------------------------------------------------------
>
>
>
> No virus found in this incoming message.
> Checked by AVG - http://www.avg.com
> Version: 8.0.173 / Virus Database: 270.7.5/1703 - Release Date: 10/2/2008
> 7:46 AM
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|