In most designs I have seen they are different lengths. I think it requires
a very good modeling program because the two driven elements interact
strongly and you need to model the physical phasing line between them
properly also. The 40m4lldd's that I have use an open wire line with a
transposition between the driven elements, similar to how lpda's are fed.
David Robbins K1TTT
e-mail: mailto:k1ttt@arrl.net
web: http://www.k1ttt.net
AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
> -----Original Message-----
> From: KZ4USA [mailto:videorov@verizon.net]
> Sent: Thursday, September 04, 2008 23:51
> To: towertalk@contesting.com
> Subject: [TowerTalk] Dual Driven elements.?
>
> Are the two driven elements tuned to the same freq? Im working on a
> antenna design and wonder how the dual driven element design is tuned?
> Is there a formula to tune them etc.
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
>
> http://www.camradio.net
>
> .
> Jack
> KZ4USA
> Bradenton, Florida
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|