You might try valve grease. It's hard to find as it's used primarily by
OEM's but it's waterproof, thick and sticky.
Brad - N8SNM
> Use waterproof boat trailer grease.
> You won't get any bee hives either!
>
> Regards
>
> Dave Harmon
> CCA 97-535
> K6XYZ[at]sbcglobal[dot]net
> Sperry, Ok.
>
> -----Original Message-----
> From: towertalk-bounces@contesting.com
> [mailto:towertalk-bounces@contesting.com] On Behalf Of Jay R. Holcomb
> Sent: Thursday, August 28, 2008 9:18 PM
> To: towertalk@contesting.com
> Subject: [TowerTalk] bees wax application
>
>
> hi,
> i saw a reference to bees wax again today for applying on a crank up tower
> where there is the steel to steel rubbing on the inside of the legs. i
> looked in the archives and didn't see any reference to what is the trick
> to
> applying it to the inside of the legs. i was able to get some from a
> local
> bee keeper. in its normal hard form, it crumbles in chunks as i try to
> rub
> it on. so then i heated it in a old pie pan, and it was like water and
> then
> solidified in minutes. looking at the tx-472, this looked like it was
> going
> to be a real chore to put on.
>
> any tricks out there?
> 73 & soft landings, jay, wa0www
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|