To: | <towertalk@contesting.com> |
---|---|
Subject: | Re: [TowerTalk] TowerTalk Digest, Vol 68, Issue 52 |
From: | "Jay Terleski" <jayt@arraysolutions.com> |
Date: | Tue, 19 Aug 2008 13:22:10 -0500 |
List-post: | <towertalk@contesting.com">mailto:towertalk@contesting.com> |
4. How do I stop 2"-OD Chromoly mast from slipping in PST-61C rotator clamp? (David J Windisch) David, If you are using the stainless steel bolts in the clamp, throw them away. They have stretched and will continue to until they snap. What I suggest is take them out and get the next size up Grade 8 bolts. Drill the 6 holes out for the new bolts. It only takes a 60 seconds to do this. Put in the new hardware and bolts. And tighten it with a lot o torque. This should fix it. Jay _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TowerTalk] How do I stop 2"-OD Chromoly mast from slipping in PST-61C rotator clamp?, David Gilbert |
---|---|
Next by Date: | Re: [TowerTalk] Guyed vs Self Supporting Lattice towers, K7LXC |
Previous by Thread: | Re: [TowerTalk] How do I stop 2"-OD Chromoly mast from slipping in PST-61C ro..., JMLTINC |
Next by Thread: | [TowerTalk] How do I stop 2"-OD Chromoly mast from slipping in PST-61C rotator, WillFrazee |
Indexes: | [Date] [Thread] [Top] [All Lists] |