Hi Felipe
I have some stubs here and they don't seem to be affected so much by where I
put them. I put mine right on the antenna switch so that they can be used
by either radio when running SO2R.
I have a 2-way switch for every antenna that comes into the shack, and the
output of each 2-way switch goes to 2 different antenna switches----1 for
each radio. I have my stubs connected right where each antenna goes to the
2-way switch. 73
Tom W7WHY
> Hello,
>
> I am trying to make a set of stubs to be used on my SO2R station setup.
>
> Those stubs should be plugged to a six pak box.
>
> When I measure the 1/4 wave shorted 40m stub, plugged directly on the
> MFJ-259, with a dummy load paralelled by a tee connector, I can see the
> nulls on 14 and 28mhz.
>
> When I plug that stub and that very dummy load on the six pak 40m port,
> things change. Nulls go to 12.9mhz and 24.9mhz.
>
> The obvious explanation is that the length of cable between the amp
> output and the six pak input is being added to the stub, right?
>
> If so, also seem obvious that I should have the same length of cable
> between both of the amps and the six pak, right?
>
> If so, I should take this length into account, and things will change if
> I turn the amplifier online, offline, right?
>
> If so, how can I deal with it in situations where I have multiple stubs?
> For example: on 40m, I plan to have 2 1/4 wave shorted stubs nulling 14
> and 28mhz, and the 1/6 + 1/12 wave for nulling 21mhz
>
> If so, I have quite a terrible problem in hands.
>
> 73 and thanks in advance for your advice,
>
> Felipe - PY1NB
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|