Towertalk
[Top] [All Lists]

Re: [TowerTalk] US Tower TX-455 Crank Up

To: wayne chapman <lk_side@hughes.net>, towertalk@contesting.com
Subject: Re: [TowerTalk] US Tower TX-455 Crank Up
From: Joe - WDØM <joe@wd0m.com>
Reply-to: joe@wd0m.com
Date: Mon, 11 Aug 2008 11:31:57 -0600
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Hi Wayne,

Check out N6RK's web site:

http://www.n6rk.com/drill_adapter_for_winch/drill_adapter_for_winch.html

I just used this approach to raise and lower my TX-455 - works like a 
champ.  I'll soon post a few pictures on my web page as well.  If you 
have a 1/2 inch drill, then about $6 in parts will get you where you 
want to go.

73

-- 
Joe Hannigan - WDØM
Pagosa Springs, CO

http://www.WD0M.com
http://www.pagosarocks.com
http://www.quiltqueen.net


wayne chapman wrote:
> Good Morning Gentleman,
> I am brand new to tower talk and to my TX-455, so please excuse me if this is 
> a duplicate question from a past entry.
> In the process of my TX-455 installation I found it necessary to raise and 
> lower it a couple of times, not being Arnold Swartzenager I also leaned very 
> quickly its not something I want to do too often. 
> So, My question is, has anyone found success with a generic 110v winch that 
> would replace the hand crank unit and be far less costly than the US Tower 
> $1500+ power unit? 
> I also have the razing fixture but I am not concerned about it as I do not 
> believe it will be necessary to tilt over the tower as often as I may want to 
> raise and lower the unit.
> Thank You in advance for any help you may be able to provide,
> Wayne, W7WAC  
> ___________

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>