Michael:
>From everything I've read in the past the two largest
wires in 8 conductor rotor wire are the power
connections from the rotor box to the rotor itself.
Usually terminals 1 and 2. At least that's what the
manual for my Ham IV says.
Couldn't tell from the msg what type of rotor you were
discussing.
Tom, WW5L
--- "Michael Fox (K5MEF)" <k5mef@mefox.org> wrote:
> I have some Belden 9405 rotator cable which contains
> two wires of 16 AWG and
> 6 wires of 18 AWG.
>
>
>
> Where should the 16 AWG wires be used - the CW and
> CCW pins? I'm thinking
> CW and CCW since those appear to provide current to
> the motor. POS, POT &
> GND seems to be for reading position off the
> Potentiometer.
>
>
>
> 73,
>
> Michael - K5MEF
>
>
>
> --
>
> We are what we repeatedly do. Excellence, then, is
> not a single act, but a
> habit. -- Aristotle
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
>
http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|