Am I having a comprehension problem? I read Peter's note as asking for
design information, to modify an antenna, with material on hand, not
where to get parts. Thanks for the links.
Mark Robinson wrote:
> I found this place which might be a good source for materials
>
> http://www.speedymetals.com/
>
>
> ----- Original Message -----
> From: "Richards" <jruing@ameritech.net>
> To: "Peter Voelpel" <df3kv@t-online.de>
> Cc: <towertalk@contesting.com>
> Sent: Sunday, 27 July, 2008 10:30 AM
> Subject: Re: [TowerTalk] 40m OWA
>
>
>> Why not get a specifications / instructions on the original design.
>> It will have the measurements and parts descriptions you need.
>>
>> After you get the design down, spacing etc., I think
>> DX Engineering and Penninger Radio both have parts that are
>> nicely made and work well for making alum antennas.
>>
>> www.DXEngineering.com
>> www.penningerradio.com
>>
>> That is where I would start.
>>
>> ============= K8JHR ============
>>
>> Peter Voelpel wrote:
>>
>>> Is there anywhere around with a good design on a 48 foot boom which seems
>>> to
>>> be proven length for that beam?
>>
>> ===================================================
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|