Do you have the manual. Take a look at Figure 13 on Page 13. Does that help?
Mark N1UK
----- Original Message -----
From: "Michael Fox (K5MEF)" <k5mef@mefox.org>
To: <towertalk@contesting.com>
Sent: Friday, 25 July, 2008 12:38 PM
Subject: [TowerTalk] Dumb rotator question
>I feel really dumb asking this, but here goes. Be gentle!
>
> I just purchased a Yaesu G-1000DXA. Upon removing from the box, the base
> unit appears to have two halves - top and bottom. There is a raised index
> mark on either side of the joint between the top and bottom. On one side
> of
> the joint, there are 4 screws which look like them might screw through to
> the other side. If that's so, I don't understand how the darn thing is
> supposed to turn.
>
> I don't see anything in the instructions about removing the screws so I
> won't touch them until I can get some clarification. Perhaps the screws
> do
> not, in fact, secure the two halves together. Even so, it looks like the
> two halves would definitely rub since the outside casing on the top and
> bottom touches all around the outside.
>
> So, I don't get it. What am I missing?
>
> Michael - K5MEF
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|