Greetings,
I recently was given an old CDE rotor, I'm thinking it's an AR-40, as it has
the familiar bell housing for the motor, but the lay flat on the table
control with the old fashioned clicketyclik as it passes stops.
When given to me I was told it didn't stop at the limits, and that's true,
and I'm interested in that.
I could live with that alone, but now I find that it has another oddity. It
always stops short of where it's been commanded. If I start with, say,
north, and command it to south, it stops 30-45 degrees short. This happens
in both directions and no matter how far it's commanded.
Now THAT makes it pretty useless, eh?
What's up wid dat? Please?
adTHANKSvance,
Mark
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|