AD5VJ Bob wrote:
> In reading the ROHN cat it talks about a serving tool used to wrap the guy
> wire back onto itself and around and around as a part of
> installing the guy wire. I can not seem to find a 'serving tool' for this
> purpose anywhere on the internet does anyone know where to
> find one?
>
>
>
> 73 fer nw es gud DX,
> QSL VIA: LotW, BUR, e-QSL
> Bob AD5VJ
> http://www.ad5vj.com/
> Old Calls WB5ZQU, WY5L/KH3, KE5CTY, N5IET
>
Good grief! How old is that catalog? From my days in the Coast Guard, I
remember my CG manual showing how to use a serving tool but never
actually saw one. It's used to form an "eye" in the end of wire rope.
It's time consuming to do correctly and dangerous if done incorrectly.
There are much better ways to do it today. Wire rope clamps, Nicopress
sleeves and preformed guy grips are quicker and easier.
I think the reason you can't find one is that no one uses them anymore!
73, Roger
--
Remember the USS Liberty (AGTR-5)
http://ussliberty.org/
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|