Gary:
I have two suggestions:
1. Use PVC conduit but intersperse handholes/pullboxes along the route. In
that way you can gain access to the conduit mid-span and pull through from one
box to the next relatively easily. You won't have to pull through the entire
length of conduit.
2. Use prefabricated trench. One manufacturer with which I am familiar (we
used it in the power substations I designed years ago) is Trenwa. You can
check out their product offerings at http://www.trenwa.com/html/Products.html .
My guess is that this will be the more expensive of these two ideas.
73 de
Gene Smar AD3F
From: "Gary E. Jones" <garyejones@cmaaccess.com>
Date: 2008/06/30 Mon PM 12:02:12 EDT
To: towertalk@contesting.com
Subject: [TowerTalk] Any ideals on heliax channel out to towers?
I am going to run at least one, and maybe two runs of Andrew Heliax out to
my two towers that are about 500' from the shack. I want to run the heliax
and some other control lines out there by laying them in a channel ("U"
shaped) (like a piece of channel iron but not steel obviously) laid flat
in a shallow trench that I plan to trench out to the towers. I would like
something that also could have a horizontal top to the trench that would
cover it and I could drive over with my lawn tractor when I move the yard.
I would like a trench so that I could easily add or remove wires from the
lines that are in the trench as I make modifications to my installation.
However, I have come up with no ideas of what to use to do this. I have
thought of perforated corrigated (flexible) irrigation pipe that I cut in
half (lengthwise) to make the bottom half in the trench and then put the
top half over the bottom half to partially cover the hole and provide the
top. My land is 100% river bed sand (at the top of a hill) so I am not
worried about drainage as any water that would get in would naturally
drain out through the irrigation holes.
However, I keep thinking that there must be some other obvious material
that would work for this application (6" PVC pipe cut in half for example)
that I am not thinking about and should be considering. I assume some
others have used systems that have worked well and not broken the bank in
getting it done.
I don't want to bury conduit I don't think... I would prefer to have it
potentially exposed....
Any ideas or suggestions ??
73
Gary W5FI
--
Gary and Dee Jones
4510 Buckingham Drive
Shreveport, LA 71107
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|