Some would say that rotors are meant to have a downward load on them and
they won't work properly without it... personally I do the same thing and
keep the weight of the mast off the rotor for the same reason. Seems to
work for me.
David Robbins K1TTT
e-mail: mailto:k1ttt@arrl.net
web: http://www.k1ttt.net
AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
> -----Original Message-----
> From: towertalk-bounces@contesting.com [mailto:towertalk-
> bounces@contesting.com] On Behalf Of ac9s@mchsi.com
> Sent: Sunday, June 22, 2008 03:03
> To: towertalk@contesting.com
> Subject: [TowerTalk] Fw: Re: Removing a Rotator
>
> I am a little behind on my email, so please excuse the late response to
> this
> thread. I have always left a little room - 1/2 to 1 inch between the
> rotator
> and the bottom of the mast. Obviously I suspend the mast by a thrust
> bearing
> at the top of the tower. This facilitates rotator swapping - I just
> unbolt
> the old rotator, tip it out the side of the tower, and swap in a new one.
> I
> have had lots of experience with HamIVs over the last few years and just
> this
> week completed a Yaesu 2800 swap - hopefully this will be completely
> overbore.
>
> Anyway, the question - Since no one mentioned this ( leaving room between
> the
> mast and the rotator) have I been engaging in a poor practice?
>
> Thanks --
>
> Keith
> AC9S
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|