Here's the problem: I have a Yaesu rotator mounted in a 55 foot crank up/tilt
over tower. The thrust bearing and 10 foot mast are also from the tower
manufacturer.
The antenna is a basic 4 element Steppir. The rotator must come out to replace
the potentiometer (hope that is spelled right). Any way to pull it without
disassembling the beam? The rotator is mounted to a plate about 4 feet below
the thrust bearing.
Mike
W8TRN
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|