Those are for the automatic slowdown as it approaches the stops. They only
did that on the 2700/2800 series, not on the smaller ones.
David Robbins K1TTT
e-mail: mailto:k1ttt@arrl.net
web: http://www.k1ttt.net
AR-Cluster node: 145.69MHz or telnet://dxc.k1ttt.net
> -----Original Message-----
> From: towertalk-bounces@contesting.com [mailto:towertalk-
> bounces@contesting.com] On Behalf Of Pete Smith
> Sent: Tuesday, June 03, 2008 10:55
> To: Joe Barnes; towertalk@contesting.com
> Subject: Re: [TowerTalk] yaesu g1000dxa vs yaesu 2800
>
> According to the manual for the G-800/1000/2800, there is an additional
> connection between the control box and pin 6 on the 2800 rotator,
> connected
> to two additional limit switches, which are not used on the smaller
> rotators.
>
> 73, Pete
>
>
> >Does anyone know if the yaesu 1000dxa is interchangeable with the 2800
> >as far as the wiring goes? I have 2 1000's right now and one alpha spid
> >and I'm thinking about replacing one of the 100's with a 2800. Thank you.
> >
> >_______________________________________________
> >
> >
> >
> >_______________________________________________
> >TowerTalk mailing list
> >TowerTalk@contesting.com
> >http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|