yes just a reed switch. I've experienced the "turns one way but not the
other" problem intermittently a few times... it's either been a damp control
cable or a damaged reed switch problem. Never had any control box issues
that caused this. If you have had a wet rainy spring possibly that started
the problem, check the isolation between the conductors. There should be a
very high or infinite ohmmeter reading betwen any of the 2 power leads and
the 2 pulse sense lines. If the positive voltage from the motor leaks onto
the pulse line it may mask the pulses - when you reverse the motor you
reverse the polarity and the negative voltage may not affect the pulses in
the same way.
73 Don
VE6JY
On Tue, Apr 22, 2008 at 3:46 PM, Deni, F5VJC <foxfive.vjc@gmail.com> wrote:
> Wonder if anyone has any info i.e. a cct diagram of the Spid rotator
> control box.
> I'm having problems with the heading indication. Pressing CW rotation
> the indicator changes as normal, but pressing CCW the rotor turns but
> the indicator "sometimes" doesn't change (seems intermittent) this only
> occurs on CCW rotation. I believe the rotor itself contains only a reed
> switch to send pulses back to the control box? Anyone have any
> information or experience of this. The rotor and control box have been
> in service for about a year without problem, so all was working fine
> until now.
>
> Thanks for any information or help with this.
>
> --
> 73, Deni
> F5VJC
>
> For a Ham radio friendly holiday in France…
>
> Visit www.mycottageinbrittany.com
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|