| To: | <towertalk@contesting.com> |
|---|---|
| Subject: | Re: [TowerTalk] hose clamps and end caps |
| From: | Bill Turner <dezrat@copper.net> |
| Date: | Mon, 03 Mar 2008 07:25:01 -0800 |
| List-post: | <towertalk@contesting.com">mailto:towertalk@contesting.com> |
ORIGINAL MESSAGE: On Mon, 3 Mar 2008 07:11:20 -0600, "Artmouton" <k5fnq@cox.net> wrote: >1. Do I just change all of the hose clamps? ------------ REPLY FOLLOWS ------------ If you suspect you have both stainless and non-stainless hose clamps, you can use a magnet to tell the difference. Good quality stainless is non-magnetic. Change any that fail the test. 73, Bill W6WRT _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] hose clamps and end caps, Bill Parry |
|---|---|
| Next by Date: | Re: [TowerTalk] hose clamps and end caps, Mike, K6BR |
| Previous by Thread: | Re: [TowerTalk] hose clamps and end caps, Tom Osborne |
| Next by Thread: | Re: [TowerTalk] hose clamps and end caps, Mike, K6BR |
| Indexes: | [Date] [Thread] [Top] [All Lists] |