I have begun doing the final assembly for my three stack of KT36XAs. The
first was hauled up to 30 feet on the side of the tower and I ran some SWR
tests on it. All three bands had SWR pretty close to what was expected. 20
was
skewed just a tad low, but that is to be expected with the height. No
problem.
The second was hauled up for testing and was a disaster. SWR was sort of OK
on 10. 15 skewed low (out of band, and bandwidth not all that wide) and 20
was over 2:1 across the band, rising as freq was increased. It was more
resonant out of the low end of the band.
Of course I checked all dimensions (six times eventually) and made sure all
obvious things were gone over (cap tubes on the right elements, orientation of
the elements) and even switched out the balun form the other "good
antenna".
Basically, the antenna behaves as though the elements are longer than they
should be even though they are not. Had the first antenna behaved this way I
might attribute it to close proximity to ground. However, the first antenna
was just fine when tested at the same height. SWR was taken right at the
feedpoint of the antenna with an MFJ259 and was also checked using the Yaesu
450
feet away on hardline, so there is no cable problem.
Mike at M2 as always has been very helpful and I'm sure we'll get this thing
up and running...eventually!
However, the combined heads of towertalk are better than just the two of us.
So...does anyone have any suggestions for what is going on. As I said, all
the obvious things have been covered. HELP!
Bill KH7XS/K4XS
**************Start the year off right. Easy ways to stay in shape.
http://body.aol.com/fitness/winter-exercise?NCID=aolcmp00300000002489
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|