> Roger,
>
> Texas Towers sells both Crimp on and Clamp on UHF (with center soldering)
> LMR-600 connectors.
Thanks, I had only seen the $30 clamp ons there.
> I would stay away from the crimp on when it comes to LMR-600 but your
> choice.
I've been using a crimp type N-Connector with a Hex nut on LMR-600 that is
an excellent connector. Much better than any of the crip or clamp on types
that we normally use on the LMR-400/9913 types of cable. Those are what sold
me on using crimp ons. <:-)) They are also about a 1/3rd the price of the
clamp ons for LMR-600 and quick to install even with the center soldering.
Roger.(K8RI)
> 73
> Andre KR5DX
>
> ----- Original Message -----
> From: "Roger (K8RI)" <K8RI-on-TowerTalk@tm.net>
> To: <TOWERTALK@contesting.com>
> Sent: Thursday, December 20, 2007 9:33 PM
> Subject: [TowerTalk] UHF Male Crimpon for LMR-600?
>
>
>> I've been hunting, but so far I've not found any male, UHF crimp on
>> connectors (PL-259 equivelant) for LMR-600. For the HF part of my system
>> I'd like to use the UHF connectors instead of N-type as some may end up
> with
>> the legal power limit and high SWR.
>>
>> 73
>>
>> Roger (K8RI)
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|