> The key here is to throw away those ratty bolts Rohn gives you with the
> thrust bearing before you install it.. Replace them with stainless steel
> AND put
> Penetrox or some anti-oxidant on the bolt so it won't freeze. It worked
> for
> me!
That's the way I do it as well, plus the addition of a locking nut. I use a
*little* Never Seize or a little of plain old Moly Disulphide grease. Just
enough to keep the threads from gauling (sp?)
Roger (K8RI).
>
> Bill K4XS/KH7XS
>
>
>
> **************************************Check out AOL's list of 2007's
> hottest
> products.
> (http://money.aol.com/special/hot-products-2007?NCID=aoltop00030000000001)
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|