Hi Everyone,
I'm posting this for a friend, Mike WBØSND:
I'm putting up a temporary beam installation and need to know the appropriate
kind of rope to use for guying the mast (poly, nylon, or ?).
The installation is a Rohn push up mast which is in concrete and bracketed to
the facia board on the house. The mast is going to extend about 8 feet above
the roof line (a total of 30 ft) and will have a Ham IV rotor and Hy Gain
Explorer 14 on top. This is just a temporary installation to get through the
winter. In the spring, I will take it down and put up a permanent tower.
So again the question is: What kind of rope should I use for the guys?
Thanks to all.
I appreciate any assistance you can provide him.
73,
Derek Cohn
Morse Telegraph Club - Alton Chapter
Office UD, Sine DJ
Amateur Radio Station - WBØTUA
1969 Brunswick M274A5 Mechanical Mule
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|