We just had snow last night so it may be cold related issue.
Just did the troubleshooting from the manual and am finding:
1) the 500ohm between 3 and 7 is present
2) it does add to 500 when going between each and ground
3) however the voltage is not 13VDC between 3 and 7
4) it is 5VDC between 3 and 7 on the back of the controller not 13VDC when
operating the motor in either direction
looking further into the wiring (possible bad wire)
appreciate if you have any ideas of guidance on where to look trying to get
ready for CQWW CW and this is no time for this to
happen.
Ever since I have had it up it has been doing fine, why now?!
tnx Bob AD5VJ
> -----Original Message-----
> From: towertalk-bounces@contesting.com
> [mailto:towertalk-bounces@contesting.com] On Behalf Of AD5VJ Bob
> Sent: Friday, November 23, 2007 11:54 AM
> To: towertalk@contesting.com
> Subject: [TowerTalk] Ham IV Rotor
>
> I just noticed this morning after some high winds (cold
> front) that came through in the last couple of days that my
> CDE controller is not following my rotor position.
>
> I had my son press the controls on the controller and tell me
> what the indicator was reading as I watched the antenna.
>
> The antenna does in fact go from stop to stop in both
> directions (stopping at North)
>
> The indicator on the controller however only goes between
> North West and South
>
> When you try to go between
> North East and South
>
> The antenna moves but the controller stops at North.
>
> Any ideas what could be wrong here?
>
> Tnx Bob AD5VJ
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|