> Missing piece of the equation:
>
> 1. How much of it will be inside the tower,
> 2. how much will be outside the tower, and
> 3. how far above the tower would this antenna be?
Really need to know the alloy as well.
The strength varies over quite a wide range.
Roger (K8RI)
>
> Can't answer until we know these things. Actually in the case of 1 and 2
> we
> need one or the other since we know the length :)
>
> I absolutely have used this exact material to hold up a Mosley Classic-33.
> The antenna was maybe 1 foot above the top of the tower. No problem.
> Higher than that? Not so certain.
>
> Mark, N5OT
>
>
> ----- Original Message -----
> From: "John Hudson" <jd_hudson@comcast.net>
> To: "Towertalk" <towertalk@contesting.com>
> Sent: Thursday, November 01, 2007 3:01 PM
> Subject: [TowerTalk] Alumimum mast
>
>
>>I found a 12' -1 1/5" OD alumimum piping that is a true .25" wall..is this
>>any count to use for a TA-33/40 meter kit or wishful thinking since it's
>>local and cheaper!!
>>
>> Thanks
>>
>> John
>> KO4XJ
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|