To: | <towertalk@contesting.com>, <frc@gofrc.org> |
---|---|
Subject: | [TowerTalk] Yaesu g-2800DXA problems with indicator going in reverse |
From: | "K2AX" <k2ax@comcast.net> |
Date: | Mon, 22 Oct 2007 21:05:47 -0400 |
List-post: | <mailto:towertalk@contesting.com> |
I have a yaesu G-2800DXA rotator and just experienced a problem. When I go clockwise the indicator needle goes fast as if there was no antenna load. Then it goes the normal rate of speed. When I let up on the control button the indicator needle stops then goes in reverse for about 15 degrees. I have used this for 5 years and no problems before this happened and there have been no changes on the tower,cables,or in the shack. Any ideas? Also when going left(ccw) the box works fine. Thanks Mark K2AX _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TowerTalk] 45g anti-climb, Roger (K8RI) |
---|---|
Next by Date: | [TowerTalk] vertical dipole - tower interaction question, Robert G. Strickland |
Previous by Thread: | Re: [TowerTalk] TowerTalk Digest, Vol 58, Issue 72, Donald Chester |
Next by Thread: | Re: [TowerTalk] Yaesu g-2800DXA problems with indicator going inreverse, David Robbins K1TTT |
Indexes: | [Date] [Thread] [Top] [All Lists] |