I own 6 TIC ring rotators and I have never used a capacitor on either the
potentiometer or the motor. The only problem that I have had with either
component was due to lightning strikes, however I never shunt fed my towers.
I'm not sure what the purpose of the capacitor is.
John KK9A
To: towertalk@contesting.com
Subject: [TowerTalk] Shunt feeding tower damages rotor
From: Paul Baldock
Date: Tue, 18 Sep 2007 13:39:33 -0700
List-post: <mailto:towertalk@contesting.com>
I have an M2 rotor at the top of my 130ft Tower fed with shielded
cable, and a TIC ring at 92ft fed with non-shielded cable. I shunt
feed the tower for 160M. All as has gone well for a couple of years.
I just changed the top antenna (much more capacitance) and had to
re-tune the tower shunt feed. This of course changes the
voltage/current distribution in the tower.
Having put 1.5KW in to the tower it seems that I damaged the TIC
Ring. At the tower the TIC ring consists of a floating motor with
.1uF to ground (the tower). The feed back pot is also floating with
.01uFcaps to ground (the tower). From measurements on the ground it
appears that I have damaged one or both of the Pot Caps to ground to
cause them to be leaky.
The question is, should I just remove the Pot Caps, or replace them
with beefier caps, or stop shunt feeding the tower.
Thanks
- Paul KW7Y
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|