According to K1VR, it was first posted on towertalk and then printed in the
NCJ .
http://lists.contesting.com/archives//html/Towertalk/2007-01/msg00421.html
----- Original Message -----
From: "jeremy-ca" <km1h@jeremy.mv.com>
To: <john@kk9a.com>; <TOWERTALK@contesting.com>
Cc: <jokamitsu@yahoo.com>
Sent: Sunday, August 26, 2007 10:00 PM
Subject: Re: [TowerTalk] Refurbishing Rohn Bearings
Excellent information and originally posted in the YCCC Scuttlebut where the
dual bearing suggestion first surfaced.
Carl
KM1H
----- Original Message -----
From: <john@kk9a.com>
To: <TOWERTALK@contesting.com>
Cc: <jokamitsu@yahoo.com>
Sent: Sunday, August 26, 2007 7:57 PM
Subject: [TowerTalk] Refurbishing Rohn Bearings
>I just did a quick archive search and found this:
> http://lists.contesting.com/_towertalk/1998-12/msg00118.html
>
>
> [TowerTalk] Refurbishing Rohn Bearings
> from [Jeffrey Okamitsu] [Permanent Link][Original]
>
> To: towertalk@contesting.com
> Subject: [TowerTalk] Refurbishing Rohn Bearings
> From: Jeffrey Okamitsu <jokamitsu@yahoo.com>
> Date: Sun, 26 Aug 2007 14:59:25 -0700 (PDT)
> List-post: <mailto:towertalk@contesting.com>
>
> Someone posted a very nice guide on how to refurbish a
> Rohn Thrust Bearing.
>
> I thought I saved it, but apparently not.
>
> Can someone please re-post?
>
> FYI. The post I'm looking for recommends the use of a
> baking pan as a work area to keep from having the ball
> bearings get all over the place.
>
> Thanks
>
> 73, Jeff
>
> W3KL
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|