Mark Robinson wrote:
>From: "Blake M" <n4gi@tampabay.rr.com>
>To: <towertalk@contesting.com>
>Sent: Sunday, 26 August, 2007 1:35 PM
>Subject: Re: [TowerTalk] Fw: Rohn 45 Question
>
>
>> The bottom bolts on a Ham IV I had would work loose every few months when
>> I
>> had no load on it (I bought into the thrustbearing-takes-the-weight thing
>> when I was new...). After I placed the full load of antennas and mast on
>> it, this problem stopped.
>>
>> Rotors have HUNDREDS of bearings in them. Most thrust bearings I've seen
>> only have 10-20.... I'm no expert in physics, but where to put all the
>> weight seems like an easy decision to me.
>Maybe a flat washer and a spring washer would stop the bottom bolts
>coming loose. Blue loctite will certainly stop them coming loose.
>
Blue Loctite is excellent for many antenna jobs. It lubricates as you
tighten the threads (prevents galling of stainless steel), locks the
threads together so they won't vibrate loose, and seals them against
corrosion... yet you can still unscrew the fastenings for maintenance.
Clever stuff.
However, threadlock is only a special type of glue, so it won't work if
the threads in the rotor casting are loose or corroded. The answer then
is to re-thread the holes to a larger size, and use *red* Loctite (the
permanent locking grade) to fix lengths of stainless steel studding into
the casting. The two parts of the rotor can then be held together by
nyloc nuts, on the underside where they're easy to work on.
--
73 from Ian GM3SEK
http://www.ifwtech.co.uk/g3sek
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|