Towertalk
[Top] [All Lists]

Re: [TowerTalk] Improvise??

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Improvise??
From: Nick Pair <daweezil2003@yahoo.com>
Date: Mon, 13 Aug 2007 14:36:22 -0700 (PDT)
List-post: <mailto:towertalk@contesting.com>
Hi Bob and group,
 
I think that the fact that you are trying for a minimalist type of installation 
with a limit of 3 sections top guyed and 10 feet or less of wind load, you can 
be safe with the following method. You will find that 3/4 inch GRC (electrical 
iron pipe) will slip into a rohn 25 leg. If you buy 10 foot section of pipe and 
have it cut into thirds with the middle piece threaded on one end, they will 
make up a set of leg extensions to place in the ground. At the same place you 
got conduit , get 3 floor flanges for 3/4 pipe to screw on threaded ends. The 
unthreaded ends need a mark 6 inches from the bald end. Use that mark as a stop 
line when you insert the pipes into the tower to use the tower as a template  
to mark where you want to drill the 1/4 and 5/16 holes for leg bolts. Drill the 
holes, and cold galvanize the holes and the cut ends of conduit, then bolt the 
legs to tower with the same grade bolts as supplied. (stainless or galvanized 
preferred) Dig hole
 about 3 1/2 feet deep and place 6 inches compacted gravel  in bottom. Be sure 
to pound that gravel as tight as you can get it. Place tower in hole and guy it 
to strong guy points as plumb as you can get it. Use a 2 foot or longer level 
or plumb bob from top center of tower. Now you can place another 4 inches of 
grave and compact it. Continue to fill the hole in 6 inch lifts, compacting it 
as much as you can between lifts till hole if filled with slight crown. As long 
as you were faithful in compacting the gravel and soil as much as you can, use 
quality guy points,  and remember the limits of this type of installation, it 
will last a long time. No adding 20 foot masts or 50 square foot antennas at a 
later time please!
Of course scrounging the conduit and floor flanges is a cost saving option too!
Not using concrete will save enough to pay for the conduit and flanges.
 
Good Luck,
Nick
WB7PEK


       
____________________________________________________________________________________
Be a better Globetrotter. Get better travel answers from someone who knows. 
Yahoo! Answers - Check it out.
http://answers.yahoo.com/dir/?link=list&sid=396545469
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>