Maybe you could use Torque Arm Assemblies at each guying level. Guys could
be attached to the three corners, leaving the tower at 60 degrees off from
the normal guying directions.
GL - 73, Tim - N3XX
----- Original Message -----
From: "Joe Eide" <jeide@execpc.com>
To: <towertalk@contesting.com>
Sent: Sunday, August 12, 2007 9:48 AM
Subject: [TowerTalk] Can't guy at normal 120 degree spots????
> Hello,
>
> I have a situation where I can't guy at the normal 120 degree angles
> which are directly in line with each of the 3 legs on a Rohn 25G.
>
> Has anyone come up with a solution, like maybe some sort of ring that
> would allow attaching guys at different 120 degree points??
>
> Thanks for your opinions,
>
> Joe - KB9R
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|