John,
Frank and Gerald are giving you the best advice. I would not even
consider using the 1200 on a temporary AB-577 with something as
large as the C-31XR on it. The 2100 is a realistic minimum for
anything more than something like a push up pole with no load!
73,
... Joe, W4TV
> -----Original Message-----
> From: towertalk-bounces@contesting.com
> [mailto:towertalk-bounces@contesting.com] On Behalf Of John Fleming
> Sent: Friday, August 03, 2007 2:31 PM
> To: TexasRF@aol.com
> Cc: towertalk@contesting.com
> Subject: Re: [TowerTalk] Philly HPTG 2100 (450 ft)
>
>
> On Fri, August 3, 2007 1:09 pm, TexasRF@aol.com said:
> >
> > John, I would not even think about guying a tower with 1200
> pound guy
> > material. In my opinion the material you have is exactly what is
> > needed for that
> > job.
>
> I apologize for starting this thread while I'm at work - I'll get back
> with you guys this evening and tomorrow!
>
> I have a 70-ft aluminum Glen Martin tower with a C31XR on top. It's
> been up since 1999 without incident until 2 guys broke due to my
> taping the ends (!). Although the 1200 is light-weight, it's as good
> as the original equipment and the whole thing could outlast me. Any
> ideas on attaching the heavier material to the tower? The thimble
> won't fit the original brackets.
>
> John, WA9ALS
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|