To: | <towertalk@contesting.com> |
---|---|
Subject: | [TowerTalk] Rohn 45 Torque bars |
From: | "Ron Todd" <ron@k4wz.com> |
Date: | Wed, 25 Jul 2007 15:17:07 -0400 |
List-post: | <mailto:towertalk@contesting.com> |
I am using Rohn 45 Torque bars and having trouble attaching the guy wire to the torque bar. I am using phillystran and using big grips. The big grips just goes through the torque arm 1/2 inch hole and thire is no room for a thimble. If I use a 3/8" Shackle they are rated only at 2,000 lbs. That dont seem enough. The Phillystran is rated at 6,700 lbs. What are your suggestions ? Ron _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | [TowerTalk] RF Rectification in audio circuits, J. Gordon Beattie, Jr., W2TTT |
---|---|
Next by Date: | Re: [TowerTalk] Rohn 45 Torque bars, TexasRF |
Previous by Thread: | Re: [TowerTalk] Why copper ground, Floyd Rodgers |
Next by Thread: | Re: [TowerTalk] Rohn 45 Torque bars, TexasRF |
Indexes: | [Date] [Thread] [Top] [All Lists] |