And if you prefer elevated radials old tower sections that would not pass
muster as a tower and aluminum sections split by ice make excellent
supports.
There are several ways to fabricate insulators for this method.
At a prior QTH I shunt fed 100 and 120' towers, both with yagis on them.
Spacing was 70' and they performed well with simple coax line phasing. F/B
was only 10-15dB but I used Beverages for RX so didnt care about that. I
moved a year later of course and had to start all over.
Carl
KM1H
----- Original Message -----
From: "Scott W3TX" <superberthaguy@adelphia.net>
To: "Roger (K8RI)" <K8RI-on-TowerTalk@tm.net>; "joe johnson"
<joe.k3rr@gmail.com>; <towertalk@contesting.com>; "Jim Lux"
<jimlux@earthlink.net>
Sent: Thursday, July 05, 2007 9:56 AM
Subject: Re: [TowerTalk] Gamma-matched 4-square
> John ON4UN addresses this question in "Low Band DXing".
>
> His advice was to avoid shunt fed elements in a driven vertical array.
>
> If the elements are dedicated (ie. not a shunt fed tower) then it is
> really
> very easy to end feed the elements (insulated from ground):
>
> Use a 6" piece of Garolite, or other suitable FRP rod, machined to
> telescope
> into the bottom section of aluminum tubing. Pour a small concrete pad
> (perhaps 1ft cubed) base for each vertical element and during the concrete
> "set" impress the FRP rod 2" deep into the center of the pad. A few days
> later sleeve the FRP rod 2" into the bottom aluminum section and cross
> bolt
> it in place. Thus there is a 2" gap between the element bottom and the
> cement pad. One of the bolts can be used as a simple connector for the
> coax
> center conductor. Place three ground rods around the circumference of the
> concrete pad. Cadweld a circular piece of plumber's copper tubing to each
> ground rod. Connect your feedline ground to one of the rods. Connect your
> radials (60 to 120 recommended) to the copper circle. Now you have a
> simple
> and cost effective base insulated element. If you ever take it down just
> pull the FRP out of it's indentation in the concrete and the FRP goes with
> you!
>
> 73, Scott W3TX
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|