I am glad this thread started. I have a Motor Start Capacitor ready to be
installed at the base of my tower which is marked 130-156 MFD 330VAC . How can
I tell if it is polarized or not? There are no + or - marks on the terminals
and I assumed (I know, I know) that it would work.
(BTW the cap at the base of the tower is to eliminate 2 wires from the tower to
the shack)
Clint - W5CPT
----- Original Message -----
From: kd4e
To: TowerTalk@contesting.com
Sent: Friday, June 29, 2007 4:30 PM
Subject: [TowerTalk] Polarized Electrolytic in Rotator Box?
May I use a 108-130UF 250VAC polarized electrolytic
starting capacitor from ACE hardware to replace the
bad one in my CDE/HamII rotator control box?
--
Thanks! & 73, doc, KD4E
Personal: http://bibleseven.com/kd4e.html
Ham QTH: http://bibleseven.com/steel/cjb-steelhouse-index.html
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|