The dimensions for the anchors are 2' X 2' X 1" Thick and the whole thing 3'
deep. The hole for each anchor would still have to be 2' X 2' X 4' . Sorry
about that --
Clint - W5CPT
----- Original Message -----
From: GALE STEWARD
To: towertalk reflector
Sent: Tuesday, June 26, 2007 2:46 PM
Subject: Re: [TowerTalk] [Tower Talk] Was something else - Now Radian
specsvs. Peoria specs ??
Don't know about the base dimensions but the anchor
dimensions look all wrong! 2 ft X 2 ft X 1 foot
deep???
I'd be more worried about the anchors than the base.
BTW, my 60 ft R25 base is 2 X 2 X 3.5 deep. I hit a
layer of red shale and couldn't easily get the last
half a foot. It's been up 29 years without issues.
I'm really confused about those anchor dimensions!
73, Stew...
SNIP...
> When Bob, NA6T posted this reply I thought the
> amount of concrete sounded a bit high. I checked the
> Radian site and sure enough that is what is listed.
> So I drug out my old Peoria Rohn Catalog, circa 1983
> and researched base dimensions. Peoria Rohn specs
> call for a 2' X 2' by 4' deep hole for the tower
> that Bob, AD5VJ is installing. It calls for guy
> anchors of 2' X 2' by 1' deep.
>
> Which raises the question: Did Radian re-engineer
> the base dimensions or did the fear of litigation
> cause Radian to up the numbers?
>
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|