Towertalk
[Top] [All Lists]

Re: [TowerTalk] Wire for Quad

To: "Bill Turner" <dezrat@copper.net>, <towertalk@contesting.com>
Subject: Re: [TowerTalk] Wire for Quad
From: "Bob Maser" <bmaser@tampabay.rr.com>
Date: Mon, 18 Jun 2007 23:05:51 -0400
List-post: <mailto:towertalk@contesting.com>
Teflon covered stranded is used by many.  How you fasten it to the spreaders 
is VERY important.

Bob  W6TR
----- Original Message ----- 
From: "Bill Turner" <dezrat@copper.net>
To: <towertalk@contesting.com>
Sent: Monday, June 18, 2007 10:56 PM
Subject: Re: [TowerTalk] Wire for Quad


> ORIGINAL MESSAGE:
>
> On Mon, 18 Jun 2007 12:56:31 -0400, "JACK KZ4USA"
> <videorov@verizon.net> wrote:
>
>>#14, 7 strand hard drawn copper wire from Davis RF. Is this good wire for 
>>my 20 meter 6 El Quad project?
>>
>>What are most people using for their Quads?
>
> ------------ REPLY FOLLOWS ------------
>
> No, no, no. Copperweld only. Copper, hard drawn or not, is relatively
> soft and will eventually break and you will have a job on your hands.
>
> Ok, copperweld will eventually break too but you get lots more years
> out of it. It is nasty, springy stuff to work with, but better to work
> with in down on the ground than fixing the other stuff up in the air.
>
> Don't ask how I know. :-)
>
> Bill W6WRT
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>