Towertalk
[Top] [All Lists]

Re: [TowerTalk] TIC Ringrotor problem

To: Barry <w2up@mindspring.com>
Subject: Re: [TowerTalk] TIC Ringrotor problem
From: Tim Duffy K3LR <k3lr@k3lr.com>
Reply-to: k3lr@k3lr.com
Date: Mon, 11 Jun 2007 11:08:27 -0500
List-post: <mailto:towertalk@contesting.com>
I think your pot may be bad. Measure the resistance from the ground between all
3 wires.

73!
Tim K3LR

Barry wrote:

> One of my Ring rotor's controllers is on the fritz.  When I turn the
> power on, the needle is pinned all the way to the left.  It doesn't move
> as I move the preset knob.  I know it's not the motor, as I swapped the
> two controllers I have and it does the same thing on my other Ring that
> works fine with the other controller.  Any ideas what might have fried?
>
> Also, does anyone have the color code for the motor's trailer hitch
> connection?  There are 6 wires, white not used, blue, green, gray, brown
> and yellow.  The manual mentions a red and there isn't a red!
> Tnx,
> Barry
>
> --
>
> Barry Kutner, W2UP
> Newtown, PA
>
> _______________________________________________
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>