Several QTH's ago I had 80 & 40M verticals sharing the same radial field AND
feed point with 1' seperation. Both worked quite well and had expected VSWR
patterns. With a multiband 4BTV you may have to experiment with open/closed
feed but at very close spacing the 80M should not distort the other patterns
to any great degree.
Carl
KM1H
----- Original Message -----
From: "N4PT" <n4pt@earthlink.net>
To: <towertalk@contesting.com>
Sent: Saturday, May 26, 2007 11:17 AM
Subject: Re: [TowerTalk] Two Verticals one radial field
>I think I have seen this discussed before but could not find it in the
>archives.
>
> I have an 1/4 wave 80 Meter vertical with about 100 radials under it. I
> would like to use an old Hustler 4BTV for the lower bands. Can I use the
> same radial field for the 4BTV? I would only use one antenna at a time.
>
> 1. What separation between the two vertical elements?
> 2. How to connect to the radial field ? A line back to the central point
> or just connect to the nearest radial ?
> 3. When using one vertical should the other vertical be grounded or open ?
>
> 73,
> Art N4PT
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|