There is a class of stainless cable hoisting grips that are similar to
the Kellems, but they are open on the side, and you lace them up around
the cable(s) with a provided stainless braided cable (about 18 ga size,
but very flexible), just like lacing up a boot. The ones I have are
branded "Andrew", but I presume they are made by someone else. I see
them at hamfests now and again, usually in the $5 range.
Disclaimer: I work for Andrew, but we have almost nothing to do with the
Cable Products guys up in IL (unfortunately)...
73,
geo - n4ua
> -----Original Message-----
> From: towertalk-bounces@contesting.com [mailto:towertalk-
> bounces@contesting.com] On Behalf Of Jim McDonald
> Sent: Tuesday, March 20, 2007 1:29 PM
> To: Towertalk Reflector
> Subject: Re: [TowerTalk] Tower Coax Support Sleeve
>
> I wasn't aware of Kellems, but I'd have used them if I had known of
> them.
> I see that you have to run the cables through them before connectors
are
> installed.
>
------------------------------------------------------------------------------------------------
This message is for the designated recipient only and may
contain privileged, proprietary, or otherwise private information.
If you have received it in error, please notify the sender
immediately and delete the original. Any unauthorized use of
this email is prohibited.
------------------------------------------------------------------------------------------------
[mf2]
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|