Rob,
First the prop pitch motor is a 24-28 v motor and will run close to 1rpm at
those voltages. The brake is energized when sufficient current passes
through the coil. But it is recommended to remove the brake components as they
are
not needed. To do this remove the motor from the gear housing, to make it
easier to handle, by tapping the large retaining NUT/Ring (castle nut) by
tapping it CCW using a soft punch. A little lubricant helps. With the motor
loose the end cap of the motor can be removed exposing the brake components.
remove the brake disk and other parts of that assembly. Replace the end cap
and
you are ready to test. There is a common lead and the other leads provide
CW or CCW rotation. In my system the power supply is nominally 32V at the
base, and can deliver 20amps. More than enough. But allowing for voltage
drop is a consideration in the selection of a power source. Green Heron and
K7NV have combined to supply a very good Power supply, control box and read
out
package. I have use Prop pitch motors as a rotator for over 35 years with
out any failures.
regards,
Norm W4QN
=========================================================
Message: 8
Date: Mon, 12 Mar 2007 16:37:27 -0700
From: Rob Frohne <frohro@wwc.edu>
Subject: [TowerTalk] Prop Pitch Doesn't Turn
To: towertalk@contesting.com
Message-ID: <1173742647.22646.19.camel@frohro-d600>
Content-Type: text/plain
Hi,
A few years ago I purchased a couple of what I believe are small prop
pitch rotors. Now that I have a need for them, I am trying to figure
out how to test them. One of them I was able to use some of the ideas
on K7NV's web site to get turning with my 13 volt power supply. It
turns at about 1/3 rpm. The other prop pitch seems to have a brake in
it, and I have been able to get the brake to click down (though it seems
that it takes a lot more current than the other one's motor does), but
the motor doesn't move. I have removed the aluminum housing, but not
the motor yet. I think I have the right wires as there are three which
look like they were used before, and according to K7NV there is a common
and the other two determine which direction it should turn. I think
this prop pitch was used to turn a Sky Needle in the past. Anyone have
any advice?
73,
Rob, KL7NA
--
Rob Frohne, Ph.D., P.E.
E.F. Cross School of Engineering
Walla Walla College
<BR><BR><BR>**************************************<BR> AOL now offers free
email to everyone. Find out more about what's free from AOL at
http://www.aol.com.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|