Towertalk
[Top] [All Lists]

Re: [TowerTalk] US Tower bearings

To: towertalk@contesting.com
Subject: Re: [TowerTalk] US Tower bearings
From: "Marlon K. Schafer" <ooe@odessaoffice.com>
Date: Sun, 11 Mar 2007 21:20:59 -0700
List-post: <mailto:towertalk@contesting.com>
Go see an implement dealer.  They can usually cross any bearing and have 
seen a ton of them.  They'll likely be a good source for new ideas....
marlon

----- Original Message ----- 
From: "Mac McCullough" <w5mc@austin.rr.com>
To: <towertalk@contesting.com>
Sent: Sunday, March 11, 2007 5:46 PM
Subject: [TowerTalk] US Tower bearings


> All ,  I am wanting to replace some of the small diameter bearings that 
> are pressed and then sort of "set" by dimpling the surrounding aluminum 
> grooved pulley ...  these bearings are used throughout the UST wire pulley 
> scheme,  presently the one I have in my hand is marked  K 8  made in USA 
> Nice Phila... or better yet has anyone replaced this  " my words " poor 
> quality bearing with a better quality as well sealed type bearing ... 
> these bearing frequently seem to seize,  thereby forcing the cable to drag 
> it's self across the pulley groove and then ruining the pulley in short 
> order ..  I love the tower,  just not these critical yet cheap bearings 
> they use ..  all suggestions welcomed ..  thanx  mac/mc  w5mc
>
>
>
> Located 46 miles due North of the Alamo, and 121 miles due South of the 
> Western White House.   see my website at  www.collinsandharrisradios.com
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>