By all means. If left unprotected the shaft will rust and the top seal will
fail which will let water into the top bearing.
Roger Halstead (K8RI and ARRL 40 year Life Member)
N833R - World's oldest Debonair CD-2
www.rogerhalstead.com
> Fwiw, it takes a face-width of around 24 inches to fit completely inside a
> section. I have one in an 18 inch faced tower, its motor hangs out one
> side, and does a fine job of turning a TH11/402CD stack. If you have an
> older one, put a bonnet on the mast to keep water out of the exposed
> bearing
> on the top.
> 73, Dave, N3HE
>
> ----- Original Message -----
> From: "Saad Mahaini" <n5ff@tx.rr.com>
> To: <towertalk@contesting.com>
> Sent: Sunday, March 04, 2007 9:19 AM
> Subject: [TowerTalk] Prosistel PST61 in Triex 470
>
>
>>
>> Hello,
>>
>> Has anyone installed the Prosistel PST61 rotor in the TriEx 470 Crank up
>> tower? I appreciate any info on this.
>>
>> 73, Saad N5FF
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk@contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|