Towertalk
[Top] [All Lists]

[TowerTalk] Problem Solved. Thanks Everyone

To: "David Jordan" <wa3gin@erols.com>
Subject: [TowerTalk] Problem Solved. Thanks Everyone
From: "Van K7VS" <wa7fab@cdsnet.net>
Date: Thu, 8 Mar 2007 15:17:34 -0800
List-post: <mailto:towertalk@contesting.com>
Thanks to all.  Got it from the horses mouth.  The original 
designer/builder.  The step I couldn't figure out was taking the top piece 
of PVC off in order to slide the unit down so I could get to the screwdriver 
moter.

Van, K7VS
----- Original Message ----- 
From: "David Jordan" <wa3gin@erols.com>
To: "Van K7VS" <wa7fab@cdsnet.net>
Cc: <towertalk@contesting.com>
Sent: Thursday, March 08, 2007 11:44 AM
Subject: Re: [TowerTalk] Disassembling at BB2/3 screwdriver antenna???


> The three or four big screws at the bottom of the pipe hold the brass
> plug.  Remove the screws and slowly pull the plug out.  Then you'll have
> access to the wires from the motor. I've done it a few times.
>
> Have Fun,
> dave
> wa3gin
>
> Van K7VS wrote:
>
>>Does anyone know how to get a BB2 screwdriver mobile antenna apart so I 
>>can
>>resolder one of the wires to the screwdriver motor??  Any help would be
>>appreciated. Tnx.  Van, K7VS
>>
>>_______________________________________________
>>
>>
>>
>>_______________________________________________
>>TowerTalk mailing list
>>TowerTalk@contesting.com
>>http://lists.contesting.com/mailman/listinfo/towertalk
>>
>>
>>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.5.446 / Virus Database: 268.18.8/714 - Release Date: 3/8/2007 
> 10:58 AM
>
> 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>