| To: | towertalk@contesting.com |
|---|---|
| Subject: | Re: [TowerTalk] Soldering RG213 to PL259 |
| From: | Ian White GM3SEK <gm3sek@ifwtech.co.uk> |
| Reply-to: | Ian White GM3SEK <gm3sek@ifwtech.co.uk> |
| Date: | Tue, 6 Feb 2007 08:00:44 +0000 |
| List-post: | <mailto:towertalk@contesting.com> |
Gary Schafer wrote: >On the nickel plated ones take a file and remove the plating where you >are going to solder. The brass under it tines quite easily. > Don't stop when the nickel is removed, but continue filing across the hole until the brass comes down to a thin edge. This makes it much easier to solder. -- 73 from Ian GM3SEK 'In Practice' columnist for RadCom (RSGB) http://www.ifwtech.co.uk/g3sek _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TowerTalk] galvanized radial wires, Richard (Rick) Karlquist |
|---|---|
| Next by Date: | Re: [TowerTalk] Rohn 25 Bolts Needed, Ethan |
| Previous by Thread: | Re: [TowerTalk] Soldering RG213 to PL259, Gary Schafer |
| Next by Thread: | Re: [TowerTalk] Soldering RG213 to PL259, Jim Miller |
| Indexes: | [Date] [Thread] [Top] [All Lists] |