Bob,
You should remove only the loose rust. If its not loose, just leave the rust
there and paint over it.
If you attempt to remove tightly adhered rust, you will remove much of
the galvanized coating as well. This will do more harm than good.
73!
Frank
W3LPL
---- Original message ----
>Date: Tue, 9 Jan 2007 00:26:04 -0600
>From: "AD5VJ Bob" <rtnmi@sbcglobal.net>
>Subject: Re: [TowerTalk] TowerTalk Digest, Vol 49, Issue 43
>To: <towertalk@contesting.com>
>
>Is this to say I should not scotch brite the surface rust away?
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|