Towertalk
[Top] [All Lists]

Re: [TowerTalk] electrically operated vertical antenna raiser

To: "'Jim Lux'" <jimlux@earthlink.net>,"'Towertalk'" <towertalk@contesting.com>
Subject: Re: [TowerTalk] electrically operated vertical antenna raiser
From: "Gary Schafer" <garyschafer@comcast.net>
Reply-to: garyschafer@comcast.net
Date: Sun, 7 Jan 2007 21:45:38 -0500
List-post: <mailto:towertalk@contesting.com>
I had the same idea Jim. I have an old garage door opener with a long lead
screw that has been lying in my garage for a few years. Even have the remote
for it!!

73
Gary  K4FMX

> -----Original Message-----
> From: towertalk-bounces@contesting.com [mailto:towertalk-
> bounces@contesting.com] On Behalf Of Jim Lux
> Sent: Sunday, January 07, 2007 2:39 PM
> To: Towertalk
> Subject: [TowerTalk] electrically operated vertical antenna raiser
> 
> I've been looking at ideas for electrically raising and lowering a
> vertical antenna (like a 6BTV or R7000 style... basically 20-30 ft of
> aluminum tubing).  One idea is to use a garage door opener (or a
> similar chain/track or leadscrew arrangement from some other source,
> but a garage door opener is probably the cheapest way to get a 8 foot
> long linear drive, 1/2 HP motor, etc.).
> 
> The other way would be to find some inexpensive gear box that runs
> at, say, 1 RPM (it would take 15 seconds to go 90 degrees) and has
> the torque capability to handle the wind load on a 30 ft mast. Any
> ideas on consumer products with this sort of capability (I don't
> think electric window drives are quite in the ballpark, but maybe?)
> 
> The moment load is about 700 ft lb for a 30 foot, 2" diameter mast in
> a 60 mi/hr wind. I suspect you could get away with a lot less as the
> drive, accepting the fact that the drive might slip if you try and
> actuate during a windstorm.  You could have mechanical stops to take
> the load once all the way up.  Of course, some drives (worm gear
> window motors come to mind) can't backdrive, and will break if
> overloaded on the output shaft.
> 
> 
> 700 ft lb @ 1 RPM is a pretty small mechanical load (550 ft lb/sec is
> 1 HP, so we're down in the 1/5th  of  HP or smaller... a pretty small
> motor, with suitable gearing..  on 12V, something like 10-15 Amps.. a
> couple amps for a 110V motor).  probably a bit much for an
> inexpensive TV antenna rotator..
> 
> 
> 
> The overall idea is to hide a vertical antenna on a rooftop by laying
> it down when not in use.
> 
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>