In a message dated 1/5/2007 9:32:38 A.M. US Mountain Standard Time,
n5ot@n5ot.com writes:
I know the answer to this question is lurking here someplace. I need to
repair a guy's KLM 4-40 feedpoint. Can you reach all of that from the
tower/mast or am I going to have to be prepared to take the antenna down?
It's been
over 10 years since I saw one of these up-close and I forget the answer :)
Mark, N5OT
Mark, KC7V and I were just up on one of his towers last Monday. That tower
has the M-Squared version of 40M4L, not fullsized, but may be the same element
spacing as yours?
Anyhow we were there to replace the balun. It is out of reach from the mast
position. Couldn't do it like planned.
73, Bob K8IA
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|